Key Features Wide frequency range: 10 MHz to 4/20/40 GHz Wide output power level range: -90/-20 to 15 dBm High frequency and output power stability Transmission and Reflection factor, VSWR, Group Delay Time measurements Power Meter and Frequency Synthesizer modes Impulse devices measurement SCPI Language Compatibility

Key Features Wide frequency range: 0.01/10 MHz to 4/20/40 GHz Wide output power level range: -130/-90/-20 to 15 dBm Highly stable output frequency and power level Low phase noise: -125 dBc/Hz for 10 kHz offset from 1 GHz carrier Pulse modulation with pulse Rise/Falloff less than 10 ns and On/Off ratio over 70 dB SCPI Language Compatibility

Key Features Frequency range: 10 MHz to 6 GHz High power range -90 dBm to +12 dBm Analog and digital modulation (AM, FM, PM, Pulse, QAM, PSK, FSK, MSK) Low phase noise: -130 dBc/Hz for 20 kHz offset from 1 GHz carrier RF Modulation bandwidth 100 MHz Playback of precalculated waveforms with sampling rate up to 125 MHz SCPI Language Compatibility

Characteristic features Measurement of S-parameters from 10 MHz to 20 GHz Dynamic range more than 100 dB Measurements in the pulsed mode: "point in the pulse", "pulse profile" Measurement of parameters of frequency-converting devices with vector calibration

Characteristics Operating frequency range from 0.3 / 10 MHz to 13.5 / 26.5 GHz Wide dynamic range: up to 145 dB High output power: up to +15 dBm High track stability: 0.06 dB / ° C Low road noise: 0.002 dB

Characteristics range of operating frequencies from 10 MHz to 20 GHz; the noise figure and the transmission factor; measurement of frequency converters with fixed and external heterodyne; built-in thermostatically controlled preselector; high speed of measurements; external converters allow to extend the range of operating frequencies up to 50 GHz; the ability to control through SCPI commands for use in test and measurement systems.

Key Features Frequency range: 100 Hz to 20/50 GHz Third-order intercept (TOI) level up to +20 dBm DANL < -165 dBm/Hz Low Phase Noise -125 dBc/Hz at 1 GHz signal from 100 kHz offset High Frequency Reference Accuracy ±0.1 ppm Resolution Bandwidth Range 1 Hz to 10 MHz Built-in input attenuator and thermostatic YIG-preselector Built-in Low-noise Amplifier SCPI Language Compatibility

Characteristics:     - full characterization of the module in less than 45 seconds at 100,000 measurements; - performance of all necessary measurements for one accession of the MRP; - the configuration of the complex for the solution of a specific problem.

Complex K2M-102 is designed to measure S-parameters of multiport RF and microwave devices. The two-port vector network analyzer P4M-18 with the port expansion unit and support of the electronic calibrator allows to measure the parameters of devices having up to 32 ports.

Complex K2M-901 is designed for the calibration of noise generators in the frequency range from 10 MHz to 20 GHz. The excess relative noise temperature (HSS) of the noise generator (GSH) is measured by comparing the noise power of the measured and reference GSN.