Main capabilities

Independent RX path based on DDC (Direct Down-Conversion) architecture
Independent TX path based on DUC (Direct Up-Conversion) architecture
2 software RXs + SubRX for each of them (4 slices total) + independent wideband Bandscope up to 80 MHz
A remote control operation, using it, you connect PTT and CW-key to the E-Coder panel. Microphone and E-Coder are connected to the remotely set up PC
TCI interface for seamless connection with third-party software, the list of software with TCI support
Professional TX processing module provides the most advanced tuning capability for voice operation
ExtCTRL connector to control external devices with 8 powerful keys with open collector
ALC connector for external power amplifiers*
Supports use of VHF transverters**
An opportunity to use the transceiver as a signal generator via DAC OUT connector (SMA connector)
An opportunity to use external filters in the middle of the RF path, using ADC IN and RX OUT (SMA connector)
Monitoring delay in CW mode is about 5-6 ms
Input for external 10 MHz reference oscillator
An opportunity to use the transceiver in SO2V mode
Full duplex or half-duplex modes***
Antenna switch with 2 HF antenna connectors and separate VHF antenna connector (Mini UHF connectors)
Internal power-meter for HF and VHF bands and SWR-meter for HF band
Ethernet LAN interface provides a fast and reliable connection to PC
* ** *** These functions are supported by the transceiver's hardware, but are not implemented in the ExpertSDR2 software. They will be supported in the future ExpertSDR2 software releases.

RF ADC, bit @ MHz 16 @ 160
ADC type LTC2209
RX Frequency range, MHz 0.1...65; 95...155
Independent software receivers 2 + 2 SubRX
Sample rate, kHz @ bit 39; 78; 156; 312 @ 24
Bandscope, MHz 80
RX HF filters, MHz LPF: 65 or 9 x BPF
RX VHF filters, MHz WideRX: 95-155 or SAW filter for 2M: 144-148
BDR on HF, dB 130
BDR on VHF, dB 114*
Sensitivity, uV 0.2
DR IMD3, not less dB 98
RMDR, dB 110
ATT/Preamp, dB -20; -10; 0; +10
VHF LNA, dB +22
RF DAC, bit @ MHz 14 @ 640
TX Frequency range, M All amateur bands 160-6; 2
Output power on HF, W 15 (up to 20)
Output power on 6M, W 15
Output power on VHF, W 7 (up to 8)
TX IMD3, dB 25-30 on HF/VHF
Local oscillator TCXO, MHz +/- ppm 20 +/- 0.5
External 10 MHz oscillator input +
Built-in audio codec, bit 24
RF input/output 2HF, 1VHF (Mini_UHF)
ADC IN, DAC OUT (SMA)
PC interface LAN 100 Mbit
DC voltage range in RX/TX, V 10...16/ 12...16
Recommended DC voltage, V 15
Current consumption RX/TX, A 1.25 / 5
Power consumption RX/TX, W 19 / 75
Operating temperature, °C/°F 0...+50/ +32...+122
Dimensions L x W x H, cm/inches 19.0 x 17.0 x 5.0/ 7.48 x 6.69 x 1.97
Weight, kg/lbs 1.5/ 3.31